Technical Requirements
for Custom Logo Products
For best results on custom
molded products please submit your logo in .TIF format approximatly
3"x 5" size.
300 DPI is required for the
accurate reproduction of your logo.
For best marketing results,
make sure to include your Website address or phone number .
Due to the nature of the
plastic molding process, small details do not show up well.
The custom parts are molded
with your artwork in the side so keep this one design rule in
mind:
"Bigger and
Bolder is Better".
The logo sizes vary between
the products manufactured for you.
The Custom 50 and TAC-50-HPR
both share the same size (approx 1" x 1.5")
The Custom 100 and Custom
150 pods share the same size (approx. 2" x 3.5")
The universal Custom Lid
is also available with your logo for an additional fee.
Two versions are available:
the "contoured" five spoke design with 1" logo
in center or the
flat "Maximum logo"
design with a 2.25" available logo area.
Custom molded Barrel Capps
also have a 1" x 1.5" logo area.
Thread Heads have a maximum
of 2 line of 10 characters or
(total area = .500" High x .950" Wide)
Nipple Heads have a maximum
of 2 lines of 6 characters
(total area = .300" High x .600" Wide )
For free design assistance
call: 888-608-7680 or email sales@allenpaintball.com